care instructions

hats
  1. Shake off, vacuum, or lint-roll the inside and outside of the hat to remove hair, dust, and lint.
  2. Use a soft-bristled brush with water and a small amount of laundry detergent or dish soap to gently scrub any stains.
  3. Rinse under cool, running water until the suds are gone.
  4. Gently wring out excess water from the cap, but do not squeeze the brim to keep its shape.
  5. Pat the hat dry with a towel and stuff the inside of the cap with a dry cloth to maintain its shape and allow to fully air-dry.
apparel
  • Machine wash cold
  • Do not bleach
  • Tumble dry low heat
  • Do not dry clean
tote bags
  • Do not iron directly over the printed design
  • Spot clean
  • Do not bleach
  • Line dry

application & removal instructions

stickers

Application:

  1. For best results, apply stickers to smooth surfaces.
  2. Clean surface with water and a cloth (alcohol and detergents can dissolve adhesive).
  3. Wipe surface dry with a dry cloth or allow surface to fully air dry.
  4. Remove easy-peel backing and flatten sticker onto surface. 
  5. Smooth out any bubbles starting from the center towards the outside edges.

Care: None needed! The durable water-resistant materials allow for our stickers to withstand the regular wear-and-tear of the elements.

Removal:

  1. Start from a corner and lift the edge of the sticker 
  2. Peel the sticker off the surface slowly, pulling the sticker over itself rather than outwards/towards yourself
    Tip: Stickers can be difficult to remove when cold. Warming up the sticker with a hair dryer or heat gun can help loosen the adhesive for easier removal
magnets

Application:

  1. For best results, ensure the metal surface is flat.
  2. Clean surface with water and a cloth.
  3. Ensure surface is dry, and free of dirt and dust.
    Tip: Applying a magnet on top of debris can damage surface and negatively affect the adhesion of the magnet.
  4. Place magnet on surface.

Removal: Peel edge of magnet and pull off surface. Reuse again and again on any metal surface!

Perpetual Recess is not responsible for damage to personal property due to improper application of stickers and/or magnets. Perpetual Recess will not replace stickers and/or magnets that are damaged due to poor application or removal techniques by the customer.